Mon–Fri 9AM–5:30PM · Sat 9AM–3:30PM · Sun Closed
Unit 102 – 12465 82 Avenue, Surrey, BC V3W 3E8604-599-1223
Darcy's Auto Service LogoDARCY'SAuto Service · Surrey BC Call 604-599-1223
Symptom Guide
Check Engine Light Diagnosis

Check Engine Light On in Surrey?

Your vehicle's onboard system detected a fault. The light flags that a problem was found — it does not name the failed part. A code scan tells us which system flagged it; testing confirms the actual cause. A steady light needs diagnosis soon; a flashing light is urgent.

Vehicle dashboard with an illuminated check engine warning light, diagnostic scan context at Darcy's Auto Service in Surrey, BC

Can I Drive With This?

Safety comes first. Use these urgency levels to decide your next move — and call us if you're unsure.

STOP

Flashing light, or flashing + shaking — reduce load and stop safely.

DRIVE WITH CAUTION

Light with rough running or loss of power — drive minimally and book now.

BOOK

Steady light with normal driving — book a diagnostic soon.

MONITOR

Intermittent light that comes and goes — get it scanned; don't assume it resolved itself.

What's It Doing?

Pick the symptom that matches what your vehicle is doing. The label tells you how urgent it is. Possible cause is not a confirmed diagnosis — testing confirms it.

BOOK

Steady light, car drives normally

Cautious short-term driving may be possible. Book a diagnostic soon — the fault is still real even if it feels fine.

STOP

Flashing light

A severe misfire can overheat the catalytic converter. Reduce engine load and stop safely. Do not continue normal driving.

STOP

Flashing + shaking

The engine is actively misfiring. Stop safely and have it diagnosed before driving further.

DRIVE WITH CAUTION

Light + loss of power or rough running

Drive minimally and book a diagnosis right away. New severe symptoms raise the urgency.

MONITOR

Light came on after refuelling

Check the gas cap is sealed and click-tight. If it clears over a few drive cycles, it may have been the cap — but get it scanned to be sure.

Possible Causes

These are common causes — not a diagnosis. We test to confirm the actual one before recommending any repair.

  • Loose or faulty gas cap

    An EVAP leak — often the simplest cause. Tighten the cap until it clicks and drive a few cycles.

  • Oxygen sensor or air-fuel ratio fault

    A sensor reading out of range, or an upstream issue (vacuum leak, fuel imbalance) skewing it.

  • Ignition misfire (spark plug or coil)

    A cylinder not firing — often pairs with shaking or a flashing light.

  • Mass airflow sensor or vacuum leak

    Unmetered air changes how the engine runs and can set a code.

  • Catalytic converter efficiency

    Often a downstream effect of an engine running too rich or lean for too long.

Frequently Asked Questions

Your vehicle's onboard system detected a fault condition. The light alone does not identify the failed part — a code scan tells us which system flagged the problem, but testing is needed to confirm the cause.

Need This Looked At?

Call us and describe what's happening. We'll help you understand what may be going on and what your next step should be — before any work begins.

604-599-1223

Unit 102 – 12465 82 Avenue

Surrey, British Columbia

Mon–Fri 9AM–5:30PM · Sat 9AM–3:30PM

Interactive Advisory

Check Engine Light On in Surrey? Start Here.

A focused decision experience — flashing vs steady, an interactive guide, "can I drive?" guidance, and a specialist agent. Never a diagnosis; testing confirms the cause.

Open the guide

Tell us what your vehicle is doing.

We'll help you understand what may be happening and what your next step should be.

Call 604-599-1223